Page 14
Inspect lift for wear, damage or any abnormal
condition
Inspect lift for rattles
Correct as needed.
Correct as needed.
750
Cycles
1500
Cycles
Maintenance and Lubrication Schedule
Upper/lower fold arms (2)
Platform pivot pin bearings (4)
Lower fold arm bearings (8)
Inner roll stop pivot bearings (2)
Inner roll stop lever bearings (2)
Inner roll stop lever slot (2)
Saddle support bearings (8)
Upper fold arm cam followers (4)
Parallel arm pivot pin bearings (16)
Handrail pivot pins (2)
Hydraulic cylinder pivot bushings (8)
Outer barrier slide/link assembly bearings (2)
Inspect Lift-Tite
™
latch rollers for wear or damage,
positive securement and proper operation (2)
Outer barrier sensor link pivot point (1) and bearing (1)
Inspect inner roll stop for:
• Wear or damage
• Proper operation. Roll stop should just rest on top
surface of the threshold plate.
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation
Inspect microswitches for securement and proper
adjustment.
Make sure lift operates smoothly
Inspect external snap rings:
• Lower fold arms (6)
• Lift-Tite
™
latches (2)
• Lift-Tite
™
latch gas (dampening) springs (4)
• Upper fold arm cam followers (4)
• Outer barrier slide/link assembly (2)
• Outer barrier actuation foot (2)
• Outer barrier link arm (1)
• Outer barrier sensor link (2)
• Inner roll stop lever bracket pins (2)
Apply grease (synthetic) to contact areas between
upper/lower fold arms. See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace damaged parts and/or relubricate.
Apply Light Oil - See Lubrication Diagram
Resecure, replace or correct as needed. See Plat-
form Angle Instructions and Platform Floor Level
Adjustment Instructions.
Replace damaged parts.
Resecure, replace or adjust as needed. See
Microswitch Adjustment Instructions.
Realign towers and vertical arms. Lubricate or
correct as needed.
Resecure or replace if needed.
Perform all procedures listed in previous section also
