Page 8
Floor Level and Inner Roll Stop Adjustments
Floor Level Switch Adjustment
Inner Roll Stop Cam Adjustment
Adjust the Floor Level switch
fi
rst
(detailed in
previous section). If the above Floor Level
Requirements are not met - adjust the inner
roll stop cam as detailed in the following pro-
cedures.
Note: Adjustment of the inner roll stop cam
affects the speed of inner roll stop deployment
and torque tube/vehicle clearance.
1. Position the lift platform approximately 12"
above stow level. See Photo B. Raising
the platform will allow access to the cam
securement screw and nut. See Photo C.
2. Use an Allen wrench to prevent the cam
locking screw from turning and loosen the
3/8
"
serrated
fl
ange nut securing the inner
roll stop cam. See Photos C and D. Do
not remove the screw or nut.
3. Using the control pendant,
press the UP
button until the platform raises fully (stops).
4. Turn the cam adjustment screw counter-
clockwise until the inner roll stop rests on
the vehicle
fl
oor. See Photo D.
4. If the inner roll stop does not rest solidly on ve-
hicle
fl
oor or the angle is more than 7°, open
the hand pump valve (turn counterclockwise) to
lower platform slightly (1/4" to 1/2"). Close valve.
See Figure A.
5. Reset the
fl
oor level switch cam to this new posi-
tion. See Photo A. Loosen the clamp securing
the torque tube-mounted Floor Level cam. Ro-
tate the torque tube-mounted Floor Level cam
until the Floor Level switch is activated (cam
depresses switch). Tighten the clamp securing
the cam.
6. Using the control pendant,
check
fl
oor level posi-
tion by lowering the platform to stow level and
then pressing the UP button until the platform
raises fully (stops).
If the inner roll stop rests solidly on vehicle
fl
oor
with 7° maximum angle (relative to the platform),
move to page 10 and check the usable platform
length as outlined.
If the inner roll stop does not rest on the vehicle
fl
oor (hovers above
fl
oor) - adjust the cam as
detailed in the following section.
Floor Level Requirements: When the lift is
positioned at
fl
oor level (raised fully), the bot-
tom of the platform must be above
fl
oor level
(threshold mat) and the inboard locator must
rest solidly on vehicle
fl
oor with 7° maximum
angle (relative to the platform).
Platform
12
"
above
Stow
Level
B
Stow Level
