page 05
SECTION 2
Programming The Operator
To set the auto-close function press
and hold the
“SET”
button until the
display shows
“P1”
. Press the
“UP”
button until the display shows
“P4”
.
When the desired setting is reached
press the
“SET”
button. The operator
will return to
“STANDBY”
mode to
indicate that the setup is complete.
5
Setting the Auto-Close Timer
Important Note:-
The Auto-Close function should not be
used unless IR Safety Beams are fitted
to the operator. Brano Industries
recommends that the Auto-Close
function be disabled. Using this function
is done entirely at the risk of the
installer and the home owner. Brano
Industries cannot be held responsible
for any damage to property and or
injury to persons.
Press the
“SET”
button to enter the
setup mode and the display will show
the current setting. Using the
“UP”
and
“DOWN”
buttons adjust the setting
until you reach the desired auto-close
time.
When the desired time is reached press
the
“SET”
button. The operator will
return to
“STANDBY”
mode to indicate
that the setting is complete.
7
Switching The Auto-Close Function
ON or OFF
The default setting for the Auto-Close
function is off. The function must be
turned on before the operator will close
the door automatically. To switch the
auto-close funtion
“ON”
or
“OFF”
press and hold the
“SET”
button until
the display shows
“P1”
. Press the
“UP”
button until the display shows
“P5”
.
The display will show the current
setting - in the default setting
“H0”
the
IR Safety Beams are disabled. Use the
“UP”
and
“DOWN”
buttons to switch
between
“H0”
- IR Beams disabled and
“H1”
- IR Beams enabled.
“10”
seconds is the minimum and
“90”
seconds the maximum that the
timer can be set to.
Press the
“SET”
button and the display
will show the current setting. Press the
“UP”
or
“DOWN”
button to switch
between
“b0”
- Auto-Close Disabled
and
“b0”
- Auto-Close Enabled.
When the desired setting is reached
press the
“SET”
button. The operator
will return to
“STANDBY”
mode to
indicate that the setup is complete.
