PCI 1 Port RS422/485
Software Setup
Chapter 3 Page 16
Chapter 3
PCI 1 PORT VELOCITY RS422/485
SOFTWARE CONFIGURATION
GUIDE
Introduction.
This section contains the installation procedures of the PCI
VELOCITY RS422/485 card, with the DOS, Windows 3.x
Windows 95, Windows 98/Millennium, Windows NT and
Windows 2000 operating systems.
The setup procedures in this chapter assume that your PC
has only one serial port present.
DOS Installation.
The DOS installation procedure consists of two steps after
the PCI RS422/485 card is inserted:
1. Determining the resources that the PCI RS422/485 has claimed.
2. Informing the Serial Solutions DOS device driver of those
resources.
Determining PCI RS422/485 Resources.
•
Insert card into PC, as described in Chapter 2.
•
Run BBCARDS.EXE, from the supplied Serial Solutions
CDROM by typing the following:
D:\diskimg\ssutil\pci\BBCARDS
Where D:\ is the Letter of your CDROM drive
BBCARDS.EXE will return a string that looks similar to
the following (values contained in the string may differ in
individual PC's due to resource availability):
card 1 is on bus 0, device 16, function 0
Card ID=5, revision 2: 1 Port Velocity RS422/485
interrupt line 11 has been assigned
