16
Phenolic Privacy Restroom Partitions, Floor-to-Ceiling — Series 700, — 69", 72" & 69"/72" Tall
Installation
6/25/2021
Bradley •
HDWC-INSTR-045 Rev. A: ECO 20-14-002S
6a Pilasters and Panels with Stirrup Brackets – Stacked Panels (Standard)
Pilasters located at walls should be mounted first. Start at one end and install a panel, then a pilaster. Continue alternating until
installation is complete. When installing in an alcove or in-corner, use an alcove bracket to secure the pilaster to the panel.
Pilasters with Panels
(Stacked Panels - Bottom)
Check to make sure the pilasters are plumb and level to each other. The pilaster height can be adjusted with the leveling screw that
was placed at the bottom of the pilaster (see page 11 for attaching leveling screw).
Refer to your submittal drawing and leave the appropriate
gaps. Standard gap is 1" (25) between the panel and wall
and 1/2" (13) between the panel and pilaster.
Spacer 6" (152) for 72" Tall Panels (72" Tall Option)
Spacer 9" (229) for 69" Tall Panels / ADA Stall (69" Tall Option)
Place the panel on the spacer and insert the panel into the
wall brackets .
A
Slide a shoe onto the top pilaster and use a piece of tape to
keep the shoe positioned about 5" (127) from the end . Make
sure the shoe mounting hole is towards the bottom .
B
Place the pilaster into the shoe secured to the floor while at
the same time placing the brackets around the panel .
C
Using the bracket as a template, drill Ø1/4" holes through
the bottom panel at each panel bracket hole . Secure the
panel to the bracket using the #10-24 x 1/2" barrel nuts and
#10-24 x 1/2" shoulder screws provided .
D
Pilasters with Panels
(Stacked Panels – Top)
Refer to your submittal drawing and leave the appropriate
gaps. Standard gap is 1" (25) between the panel and wall
and 1/2" (13) between the panel and pilaster.
Spacer 6" (152) for 72" Tall Panels (72" Tall Option)
Spacer 9" (229) for 69" Tall Panels / ADA Stall (69" Tall Option)
Using the bracket as a template, drill Ø1/4" holes through
the top panel at each panel bracket hole . Secure the panel
to the bracket using the #10-24 x 1/2" barrel nuts and
#10-24 x 1/2" shoulder screws provided .
F
Cut the H-bracket to the same size as the panel and
place onto the bottom panel . Place the top panel into the
H-bracket and stirrup brackets as shown .
E
