Bpt XT/200, Instructions Manual

Page: 23 / 88

PROGRAMMING
23
ENGLISH
Default settings
• Call volume: 3 (highest level).
• Call note: melody 1.
• Hands-free volume: 3 (highest level).
• Dialling mode: DTMF.
• Pause length: 1 s.
• R key (flash): 100 ms.
• Audio/video function keys: enabled with
bpt telephone interface.
The programming mode can be entered
either with the receiver lifted or in hands-free
mode.
You can tell you have entered programming
mode as the red LED comes on and there is
no dial tone.
Ot is not necessary to exit and reenter the
programming mode when programming a
number of functions.
During programming, pressing any of the
keys produces a short beep, the storing of
the data produces a longer sound, and
errors an extended beep.
WARNING. If the programming is carried
out with the unit connected to the local line,
after approx. one minute, the dissuasive
action of the telephone exchange may inter-
fere with programming. In this case, hang up
the receiver and resume programming from
where you left off.
Storing one-touch numbers
Lift the receiver
or
press the hands-free key.
Press the PROGRAMMING
key.
Press the ONE-TOUCH
DIAL key.
÷
Press the key the telephone
number is to be associated
with (in the range
0 to 9 ).
Key in the desired number
(max. 20 digits) (
1 ).
Press the ONE-TOUCH
DIAL key to save.
Press the PROGRAMMING
key.
Replace the receiver
or
press the hands-free key.
Repeat the operation to store the next num-
ber. Up to 10 different numbers can be sto-
red.
(
1
) If the telephone is connected to a switch-
board, a pause must be inserted between
the
0 (number dialled to get an outside line)
and the telephone number .
To insert a pause, press the RP key e.g. 0
RP 0123 456789 .
The length of the pause can be doubled by
pressing the
RP key twice.
0…9
2
3
4
0
5
6 1
7
8
9
9
0
0…9
XT/200 2403-7422 11.2001 31-05-2002 11:32 Pagina 23