28 Setup
Entry and Exit
EPC Keyboard:
Press Ctrl-Scroll Lock to both enter and exit setup. Also, press
F14 or Pause to exit.
ANSI Keyboard:
entry is dependent upon the Setup selections:
þ
When “F1 to F5 keys” = Local, press F1 to enter.
þ
When “F1 to F5 keys” = FKey, press Ctrl-F3 to enter.
þ
When “Key Mode” = Scan Code, press Ctrl-Select to enter.
Saving Parameters
Upon exiting setup mode, the prompt “Save All (Y/N)” blinks. Press
Y
or
y
to exit
setup and save settings in permanent (nonvolatile) RAM. Press
C
or
c
to cancel the exit
request. Press
N
or
n
to exit Setup. The changes will take effect, but will be lost if the terminal is reset
or powered off.
An exception to this is function/edit key and answerback message programming.
Once edited in Setup, the changes are saved regardless of the way in which you exit
Setup.
Movement Inside Menus
F1 through F12:
Select the menu that corresponds to the function key. Depending on
your keyboard, there will be another key, either F13 or the Print Screen key (on the
EPC keyboard) available to access the “EXEC” menu. These keys are always active
within Setup and are labeled at the top of each menu.
Cursor Control Keys (
↑
↑
←
←
↓
↓
→
→
):
These keys control movement to parameters
within the menu and is indicated by a highlighted selection bar. This selection bar will
wrap to the other side of the menu at the top, bottom and side boundaries. For each
parameter there are at least two choices. As the parameter is highlighted, the available
choices appear in the area above the help bar.
Some parameters are action fields and have no choices. See the Action Fields
section later in this chapter.