Boumatic Xpedia 360 EX, Installation Instructions Manual

Page: 13 / 91

9e1006b
Page 13
3. DESCRIPTION
3.1 ASSEMBLY INSTRUCTIONS AND EXPLANATION OF SYMBOLS
This stall system is delivered in individual parts. It must be assembled by trained personnel, taking into account
the contents of this manual.
Installation personnel must have knowledge of the type of installation and possible risks.
The instructions in this manual must be followed. BouMatic accepts no responsibility or warranty for damages
resulting from improper installation and their consequential damage.
The following information must be observed:
During welding operations, in particular of galvanised parts, harmful gases can lead to damage to health.
Avoid breathing these vapours and ensure adequate ventilation.
Adaptations, e.g. cutting certain parts, requires mechanical expertise.
A bitumen coating shall be applied to all parts to be encased in concrete up to 50 mm (2 “) above the top
edge of the finished concrete.
If possible, use greases approved for the food industry, such as “Unil Opal Polyfood 2” or a comparable
lubricant.
Always grease stainless steel screws before mounting..
If you weld galvanised surfaces or galvanised parts mechanically, immediately apply a new zinc coating.
For screw connections, observe the permissible torques (see table on the next page).
Ø Screw
Torques of the fixing screws (Nm)
Strength class
4.6 4.8 5.6 5.8 6.6 6.8 8.8 10.9 12.9
M4 1.12 1.50 1.40 1.87 1.68 2.25 3.00 4.21 5.06
M5 2.17 2.89 2.71 3.62 3.26 4.34 5.79 8.15 9.78
M6 3.74 4.90 4.60 6.24 5.62 7.49 9.99 14.00 16.80
M8 8.92 11.90 11.10 14.80 13.30 17.80 23.70 33.40 40.10
M10 17.90 23.80 22.40 29.80 26.80 35.80 47.70 67.20 80.60
M12 30.40 40.50 38.00 50.70 45.60 60.80 81.10 114.10 137.00
M16 73.40 97.90 91.80 122.40 110.20 146.90 195.90 275.60 330.70
M20 143.20 191.00 179.00 238.70 214.80 286.50 382.00 537.10 644.60