19
NOTE:
As long as the Programmer is plugged in (connected to AC
power), the battery will charge. The Programmer does not have to be
powered on to recharge the battery.
Prepare a Telemetry Wand
Depending on the PG being used, prepare the appropriate wand.
Model 6395 Telemetry Wand
CAUTION:
The Model 6395 Telemetry Wand is shipped non-sterile. Remove
the wand from all packaging material before sterilizing it. If the wand is to be
used in a sterile field, it must be actively sterilized before use or enclosed in a
disposable sterile surgical sheath (Model 3320) during use. Refer to "Cleaning
the Programmer and Accessories" on page 43 for sterilization and cleaning
information.
If needed, prepare the Model 6395 Telemetry Wand for the sterile field by
following the procedures in "Cleaning the Programmer and Accessories" on
page 43 or by enclosing the wand in a Model 3320 Sterile Sleeve.
Model 3203 S-ICD Telemetry Wand
CAUTION:
The Model 3203 S-ICD Telemetry Wand is shipped non-sterile.
Remove the wand from all packaging material before use. If the wand is to be
used in a sterile field, it must be enclosed in a sterile intraoperative probe cover
(Model 3320) during use. Refer to "Cleaning the Programmer and Accessories"
on page 43 for cleaning information.
To use the Model 3203 S-ICD Telemetry Wand as an additional antenna for RF
telemetry, refer to "Prepare for ZIP (RF) Telemetry" on page 22.
If needed, prepare the Model 3203 S-ICD Telemetry Wand for the sterile field
by enclosing the wand in a Model 3320 Sterile Sleeve.
Cable Connections
For connector locations, refer to the panels on the Model 3300 Programmer
System right side and left side (Figure 2 Right Side Panel of the Programmer
on page 17 and Figure 3 Left Side Panel of the Programmer on page 17).
Make Patient Side Connections
As needed, make the following connections on the right side of the
Programmer.
