30
en | Installing the Pipe Mount
AutoDome Pipe Mount
F.01U.251.410 | 1.0 | 2011.08
Installation Guide
Bosch Security Systems, Inc.
3.
Drop the Pendant down slightly to engage the dome hook
and hinge pin of the Dome Cap, allowing the dome to
rotate around the hinge pin.
4.
Rotate the dome housing down to a vertical position and
gently push upward to engage the connector on top of the
dome housing.
5.
Hold the housing firmly in position and alternately tighten
the two (2) 5-mm Allen head mounting screws from above
to a torque value of 10-12 N-m (90-105 in.-lbs).
6.
Rotate the arm to swing the AutoDome out from the roof
and into position.
7.
Tighten the three (3) 10-mm (3/8-inch) stainless steel hex
bolts on the bracket to lock the Parapet Arm in position.
Refer to
Figure 2.9, Page 29
, for an illustration.
CAUTION!
If you feel any resistance when rotating the dome housing or
when engaging the connector, stop immediately and start over.
CAUTION!
You must tighten the two mounting screws to a minimum
torque of 10-12 N-m (90-105 in.-lbs) to ensure a proper seal
between the arm and the housing.
CAUTION!
Do not over tighten the bolts. The maximum torque is 34 N-m
(25 ft-lb).
