AutoDome Easy IP
Configuring IP Communications | en
39
Bosch Security Systems, Inc.
Installation Manual
F01U079609 | 1.0 | 2008.08
8.3
IP Network Address Requirements
To operate the camera in your network, you must assign it a
valid network IP address. The default IP address is 192.168.0.1,
but you may have to change this address if it conflicts with
another device on your network or if you connect more than
one (1) unit.
To properly configure the camera for your network, you need
the following information:
–
Unit IP address: an identifier for the camera on a TCP/IP
network. For example, 140.10.2.110 is a valid syntax for an
IP address.
–
Subnet mask: a mask used to determine what subnet an IP
address belongs to.
–
Gateway IP address: a node on a network that serves as an
entrance to another network.
–
Port: an endpoint to a logical connection in TCP/IP and
UDP networks. The port number identifies the use of the
port for use through a firewall connection.
The AutoDome Easy IP defaults are as follows:
–
IP address: 192.168.0.1
–
Subnet mask: 255.255. 255.0
–
Gateway IP address: 0.0.0.0
The following sections provide instructions about installing the
software necessary to view images over an IP connection,
configuring the IP network settings and accessing the
AutoDome Easy IP images from a web browser.
8.4
Connecting the AutoDome Easy IP to the
PC
1.
Install the AutoDome Easy IP according to the instructions
presented earlier in this Installation Manual.
i
NOTICE!
Ensure that the network parameters of your cameras are
available before you begin configuration.
Summary of Contents for VEZ IP Series
Page 1: ...AutoDome Easy IP VEZ IP Series en Installation Manual ...
Page 2: ......
