Bosch VEZ-400 Series, Operation Manual

Page: 43 / 78

On-Screen Display (OSD) Menu
Notice!
Before beginning this section of the manual, you must install and connect the camera to an
interface device. Refer to the Mounting Manual. Once you have installed the camera, apply
power to the camera.
When the camera is powered-up, the start-up screen appears on the monitor.
VEZ-400 MINI PTZ
DOME
RS-485/9600
ID001
CAM TEST ...PASS
Basic Navigation and Common Actions
Camera operators can operate the camera by two methods:
–
Use of hot keys [Refer to Bosch Protocol, page 72].
– Use of the OSD Menu displayed on the monitor [Continue to read this chapter].
The following table identifies the symbols that depict actions of the joystick controller, or the
keys on the keyboard, that control the camera.
Notice!
The step-by-step instructions in this chapter are written with the idea that camera operators
know the joystick/keyboard commands (listed in the table below) for actions (Select, Clear,
Save, Exit).
Command Action
▲ Move the joystick up to select an item.
▼
Move the joystick down to select an item.
◄
Move the joystick left to select options for
an item.
►
Move the joystick right to select options
for an item.
►
/ [Open]
button / [Near]
button
Move the joystick right to select, change,
or save values, or to go to edit pages.
10
10.1
AUTODOME 4000 Mini PTZ Dome On-Screen Display (OSD) Menu | en 43
Bosch Security Systems, Inc. Operation Manual 2015.08 | |