Bosch VEZ-400 Series, Operation Manual

Page: 17 / 78

3. Pre-drill the four screw holes wide enough to accept the plastic anchors.
4. Cut out the entire cable conduit hole.
5. Insert the four plastic anchors (item 2) inside the pre-drilled holes.
6. Route the cables from the camera through the conduit in the ceiling.
7. Remove the dome cover (item 6) from the camera base (item 3).
Notice!
To prevent scratches on the dome cover, Do Not Remove the plastic film protecting the dome
cover until after hardware installation is complete.
8. Remove the white foam ring from the camera base, and remove the white foam sheet
from the inside of the dome cover. (These are for protection during transport.)
9. Align the four screw holes on the camera base (item 3) with the four plastic anchors.
!
Caution!
When (re)mounting the camera base, make sure that each mounting screw has a rubber O-
ring. This ensures protection against water ingress.
10. Attach the camera base to the ceiling using the four #8 x 32 screws (with O-rings
attached) (item 4). Tighten the screws enough to ensure that the camera base is secured
to the ceiling.
11. Make the necessary Dip Switch settings (described in chapter 4.3). Note: This step can
also be done later, but then the dome cover must be re-opened.
!
Caution!
When (re)mounting the dome cover to the camera base, make sure that each screw has a
rubber O-ring, and that the large rubber O-ring is in place on the camera base. This ensures
protection against water ingress.
12. Align the screw holes on the dome cover (item 6) with the camera base.
13. Attach the dome cover to the camera base using the four M4 x 12 Torx screws (with O-
rings (item 4) attached) using the supplied Torx wrench. Make sure that the large rubber
O-ring between the camera base and dome cover is in place to protect the camera against
water ingress. Tighten the screws enough to ensure that the housing is secured to the
camera base and that the rubber O-rings seal the dome cover against water ingress.
14. Remove the plastic film protecting the dome cover from scratches.
AUTODOME 4000 Mini PTZ Dome Installing a Surface Mount (AUTODOME 4000) | en 17
Bosch Security Systems, Inc. Operation Manual 2015.08 | |