Bosch VEZ-400 Series, Operation Manual

Page: 21 / 78

Installing the Camera to the Recess Mount
To install the camera to the recess mount, follow these steps:
!
Caution!
All wires for installation applications must be routed through a grounded conduit.
1. Route wires on the side of mounting plate with the crescent shaped cut-out.
2. Connect the cables according to the instructions in the Operation Manual for the
AUTODOME 4000 camera.
a
b
Figure 6.6: Match Connectors
1 24 VAC power (black with 2p connector)
2 RS-485 (white/blue with 2p connector)
3a 3-pin I/O terminal (Alarm NC/COM/NO) (multi color)
3b 5-pin I/O terminal (Alarms and ground) (multi color)
4 Video (black with yellow connector)
5 Cutout for cable
3. Attach the camera to the recess mount by removing the bubble from the camera (use the
wrench supplied with the camera), and attaching the camera base to the mount using 4
M4 mounting screws with rubber ring (supplied with the camera). Ensure that the cable
is aligned with the cutout in the recess mount.
4. Attach the camera base and make the necessary DIP switch settings, and then install the
bubble. (See the camera User Manual for details.)
6.4
AUTODOME 4000 Mini PTZ Dome Installing a Recessed Mount (AUTODOME 4000) | en 21
Bosch Security Systems, Inc. Operation Manual 2015.08 | |