58300000111195_ARA_en_f.doc – 02.06.09
Seite 14 von 102
3.4.2 Water
filter
A water filter available as an accessory (mat. no.: 46 1732) can be
inserted in the water tank.
When approx. 50 l of water have run through (corresponds to approx.
400 brews) or after 2 months at the latest, the effect of the filter is
depleted. The filter must then be replaced. (Risk of bacteria!)
Insert filter into the water tank, then change the appliance settings
according to instructions enclosed with the filter.
Note:
►
Do not insert the filter if the red illuminated ring
around the
calc
button on the appliance is lit.
The appliance must be descaled first.
►
Before descaling the appliance, take the
inserted water filter out of the water tank.
►
If softened water from a domestic softening
system is used, a water filter is not required.
►
If the change filter system message is
displayed, immediately replace or remove used
water filters. If no new water filter is inserted,
adjust the water hardness.
To activate the filter and ensure correct function, the
inserted filter must be rinsed. Observe the following
points.
3.4.2.1
Inserting the water filter
►
The appliance must be in
stand-by mode.
►
Place a vessel with a
capacity of at least 500 ml
under the hot water nozzle.
►
Insert the water filter
according to instructions
enclosed with the filter.
►
Simultaneously hold down the
calc
and
clean
buttons for at
least
3 sec
.
The display changes to:
►
Keep pressing the
calc
button until the filter symbol lights up.
►
Acknowledge by pressing the
cafe
button.
►
Rotate function selector to draw hot water.
The appliance rinses the filter automatically. Water is conveyed into
the collecting vessel (approx. 2 minutes). The water may be a little
cloudy, do not drink it!
►
If the turn on coffee system message is displayed, turn
function selector back to brew coffee.
The appliance is ready for use again.
