Bosch rexroth MCL, Project Planning Manual

Page: 17 / 206

2 Important instructions on use
2.1 Appropriate use
2.1.1 Introduction
Bosch Rexroth products are designed and manufactured using the latest
state-of-the-art-technology. Before shipping, all products are checked for
safety.
However, the products may only be used in compliance with their appropriate
use. If they are not used as intended, property damage and personal injury
may occur.
Bosch Rexroth, as the manufacturer, does not provide any war‐
ranty, assume any liability, or pay any damages for damage
caused by products not being used as intended. Any risks result‐
ing from the products not being used as intended are the sole re‐
sponsibility of the user.
Before using the products by Bosch Rexroth, the following condition prece‐
dent must be fulfilled so as to ensure that they are used as intended:
●
Personnel that in any way uses our products must first read and under‐
stand the relevant safety instructions and be familiar with their appropri‐
ate use.
● Hardware products must be left in their original condition, i.e. no struc‐
tural changes may be made. Software products must not be decompiled
and their source code must not be changed.
● Damaged or defective products must not be installed or put into opera‐
tion.
● It must be ensured that products are installed in compliance with all reg‐
ulations specified in the documentation.
2.1.2 Areas of use and application
Ironless linear motors MCL of Bosch Rexroth are intended for use as linear
servo drive motors.
For application-specific use of motors, drive controllers with various levels of
power, DC bus voltage and different interfaces are available. For regulation
and controlling of motors, additional sensors like length measuring systems
must be connected.
● The motors may only be used with the accessories and at‐
tachments specified in this documentation. Components that
are not explicitly specified must not be installed nor connec‐
ted. The same applies for cables and lines.
● The device may only be operated in the explicitly specified
configurations and combination of components and in com‐
pliance with the respective functional description of the soft‐
ware and firmware.
Before commissioning, every connected drive controller must be program‐
med according to the specified motor function for the specified application.
The motors may only be operated under the assembly, mounting and installa‐
tion conditions, in the normal position, and under the environmental condi‐
MCL Ironless Linear Motors 9/197
Important instructions on use
R911330592_Edition 06 Bosch Rexroth AG