Bosch Rexroth IPC 40.2, Project Planning Manual

Page: 36 / 82

7-6
Connections IPC 40.2
DOK-SUPPL*-IPC*40.2***-PR02-EN-P
Ethernet Interface XEthernet
The IPC 40.2 can be connected with an Ethernet network via the
XEthernet interface.
RJ45 female connector, 8-pin
Type: Ethernet 10Base T / 100Base X
Cable length: Max. 100 m
Cable type: Shielded, twisted pair
Transmission rate: 10 or 100 Mbits/s
max. 100 m
1
8
2
1
3
4
5
6
7
8
XEthernet RJ45
To the network
XEthernet
ethernet_sst.cdr
Fig. 7-6: Ethernet interface XEthernet
The driver configuration of the network connection can be called up in the
task bar or in the "Control Panel" with icon "Network Board". Here you can
set among other values, if the data transfer shall occur with 10 Mbits/s
and/or with 100 Mbits/s.
Note: Please observe that the network board of the outstation has to
be able to process the same data transmission rate.
VGA Interface XVGA
An external monitor (CRT) can be connected to the VGA connection
(XVGA) and can be operated parallel to the integrated flat screen via the
integrated video adapter.
•
Video RAM: Max. 8 MB
Note: Please observe that the external monitor has to be already
connected during the booting process of the IPC 40.2, as
otherwise the VGA interface is not initialized by the BIOS.
Note: Before plugging-in a graphic card the video adapter integrated
in BIOS has to be switched off.
XEthernet – Network connection
XVGA – Connection for an
External Monitor