8 Start-up
8.1 Initial
start-up
CAUTION
Sudden movements, falling workpiece pallets
Injuries caused by falling objects.
Make sure that the product has been installed properly by qualifi ed personnel
(see page 9) before starting it up.
NOTICE
Malfunctions due to incorrect assembly and start-up
The product can get damaged, shortening its service life.
Start-up requires basic mechanical, pneumatic and electrical knowledge.
The product may only be operated by qualifi ed personnel (see page 9)
• Before the initial start-up or re-commissioning of a conveyor system, carry out a
risk assessment in accordance with DIN EN ISO 12100.
• In accordance with the EU Machinery Directive 2006/42/EC, transfer systems must
be equipped with EMERGENCY STOP devices.
• The surfaces of motors and gears can reach temperatures of over 65 °C under
certain load and operating conditions. In these cases, you must comply with the
respective applicable accident prevention regulations (UVV) by taking appropriate
structural measures (guards) or by affi xing/displaying appropriate warning signs!
• Make sure that all the electrical and pneumatic connections are either in use
or covered. Make sure that all bolted connections and plug-in connections are
properly seated. All relevant protective covers must be fi tted.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the safety guards are in place.
• Observe EN ISO 13857 when you remove or replace safety guards and/or bypass
safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only start up the product if all safety equipment has been installed in the system
and is functional.
• Only start up a product that has been completely installed.
Start-up 45/72
3 842 562 241/2019-04, MIT: HQ 2/U-H,
Bosch Rexroth AG
EN
GLISH
