6
PAR: reset parameters to factor defaults
A text page will come out to confirm the action.
5
GROUND SPEED CALIBRATION
There are two ways to do the speed calibration.
If the resolution is known, just manually input the pulses per KM or Mile.
The other way is to set up the predetermined speed as the speed that truck will run more often. Follow the hints
on the screen and allow the system to finish the speed calibration by itself.
After the predetermined speed is set up, it jumps to the following screen and text message “Run CAL SPD &
press START” will flash.
Hold the vehicle speed which is indicated on the vehicle’s speedometer to the CAL SPD before press
START
.
After 5 seconds, the system will record the pulse resolution automatically. The speed calibration is completed
now.
If known, enter
the
pulses/Km(or
Mile)
To run calibration
procedure press
“Skip”. You must
drive constant at
the cal speed and
press “Start”
Set cal speed if
you will be
running the
speed
calibration
Run CAL SPD & press Start
ABORT START
