44
en | Installation material and tools
DICENTIS
2021.01 | V2.2 |
Hardware Installation Manual
Bosch Security Systems B.V.
3
Screw holes
Used to mount the device on a flat surface
4
Cable tie recess
Used to secure the device, preventing side movement
Mounting
To secure the DCNM-IDESKINT to a flat surface, insert two 2.5 mm screws in the existing holes
on the flaps (3). You can also fix the DCNM-IDESKINT by wrapping a cable tie around the
device using the existing recess (4) to prevent side movement.
C
B
A
Figure 5.13:
Screw max dimensions
Flat head
A
8 mm
B
2 mm
C
2.5 mm
Connection
USB-B to USB-A
The interface is connected to the USB-A port of one of the DCNM-IDESK devices inside the
interpreter’s booth. The maximum length of the USB cable is 5 m.
Note:
the USB cable must be purchased separately.
8-pin Phoenix connector
The 8-pin Phoenix connector interfaces with the external telephone system and booth on-air
LED. The input of the connector is used for the external telephone system, while the output is
used for the external booth on-air LED. See the image and table below for reference.
Figure 5.14:
8-pin Phoenix connector
Summary of Contents for DCNM-APS2
Page 1: ...DICENTIS Conference System en Hardware Installation Manual ...
Page 2: ......
Page 79: ......
