EN
© 2005 Bosch Security Systems
Page 13 of 40
Photo 2H Optional tamper clip
2.9
To install the trim ring, align the yellow dots on the
inside of the trim ring with the yellow dots on the locking
ring. To ensure proper installation, push on the trim ring
vertically until a click is felt. Installation is now complete.
If using the FastAddress feature, see SECTION 3 for
additional information.
2.10
INSTALLATION
Installation should be performed by qualified service
personnel only, in accordance with the National
Electrical Code or applicable local codes.
The AutoDome system is suitable for use in environmental air
spaces or in an air handling plenum of a nonfire-resistant
ceiling.
Do not remove camera from pan/tilt. Remove the entire
receiver/driver, pan/tilt, and camera assembly from the
AutoDome system to prevent damage to the
flexible cable and connector.
SECTION 3
FastAddress
The FastAddress feature allows the AutoDome’s cameras to be
addressed (or the address may be changed) via a keyboard and
on-screen menus instead of using the switch address (thumb-
wheel). If FastAddress is not used, the camera’s address defaults
to the address indicated by the thumbwheel switches.
Conversely, if FastAddress has been programmed, the
thumbwheel switches are ignored.
There are two commands used to address the AutoDome via the
FastAddress feature:
•
ON-999-ENTER: All domes that have not already been
configured using FastAddress will respond to this command.
Additionally, if the address of a previously configured dome
matches the camera number at the keyboard, that dome will
respond to the command as well.
•
ON-998-ENTER: All domes respond to this command,
regardless of FastAddress status.
NOTE:
In systems with multiple monitors, other domes may
also enter the FastAddress mode. As commands (which are
unique for each dome) are entered, the other domes
automatically exit the FastAdress mode, and only the target
dome remains active. Following are some instances when
FastAddress would be used:
1. New or existing installation of an AutoDome(s):
a. Set the keyboard to display the camera, for example,
CAMERA-3-ENTER (where 3 is the camera whose
address you’re identifying/changing).
b. Press ON-999-ENTER, and follow the instructions on the
screen (see FIGURE 3A).
REMINDER:
All domes that have not already been
configured using FastAddress will respond to
ON-999-ENTER.
c. When a camera is being moved, the dome may
already have an address, therefore it will not respond to
ON-999-ENTER. In this case, you must use
ON-998-ENTER to readdress the camera, then follow the
on-screen instructions.
d. There is a visual confirmation that the address was set.
2. Clearing the address of a camera (causing the address of the
camera to revert back to the address set by the thumbwheel):
a. Enter FastAddress mode using either method described
above, then follow the on-screen instructions
(see FIGURE 3B).
b. At the end of FastAdress mode, press OFF-1-ENTER to
clear the address.
Section 3
