Starting up
39/56
3 842 358 796/2015-01, MIT: HD 2/H,
Bosch Rexroth AG
8.6 Reduce stroke over conveyor level
WARNING
Unexpected movements
Risk of serious injury and even death.
Final commissioning may only be performed with guards in place
These must be provided and installed by the customer.
Do not leave objects on the lift rotate unit
NOTICE
Improper adjustment can result in property damage
The product can be damaged; the service life may be adversely affected.
If both stop screws are not set at precisely the same level ±0.1 mm the lift
rotate unit can be damaged or can wear prematurely.
Fig. 23:
358 732-23
h
1
= h
2
(±0,1 mm)
2
SW
A
3
SW
A
M
D
=
B
h
1
1
3
4
h
2
Set the stroke over the conveyor level (example shown here size 2 180°)
Please note:
• It is recommended not to
change the factory preset
stroke.
• If the hub is to
nonetheless be reduced,
both stop screws must be
precisely adjusted to the
same height ±0.1 mm.
• Perform the adjustment
of the stroke at lower end
position of the lift rotate
unit.
1. Loosen lock nut
2. Adjust the stop screw to
the desired height.
3. Counter stop screws
4. Check stop screws
for identical height
adjustment.
Stop screws and lock nuts
Size
HD 2/H
A
SW
[mm]
B
M
D
[Nm]
Sz* 1
16
20
Sz* 2/3
18
25
*) Sz = size
EN
GLISH
358732_2015_01_EN.indd 39
358732_2015_01_EN.indd 39
29.05.2015 08:32:59
29.05.2015 08:32:59
