628 & 698 Models
70
Water Tubing Replacement - Step by Step Guide
1. Remove the two retaining
screws from the back of top
lid and remove lid.
2. Disconnect existing white
tubing from push-fit elbow
on cold tank as shown.
3. Disconnect other end of
existing white tubing from
bulkhead fitting inside and at
the back of the lower
compartment.
4. Draw out the existing tubing
from the top and discard.
5. Rotate the push-fit elbow
one-half turn
6. Take the replacement tubing,
(as supplied) and straighten
one end. Insert the
straightened end into the
same tank shelf cut-out as
the existing tube was
withdrawn from, taking care
to pass through to the right
hand side of the existing
wiring loom.
Summary of Contents for 628
