Borg & Overstrom 628, Installation & Operation Manual

Page: 60 / 81

628 & 698 Models
60
Hot Tank Replacement Procedure
Tools Required
10-Ltr Bucket
1Litre jug
*1Pt Long Blade Phillips Screwdriver (250mm blade min)
Flat Blade Screwdriver
Side Cutters
Estimated time 20 minutes
*Preferable, otherwise a standard short bladed version can be used.
1. Switch off the two switches on back of the machine and disconnect the power lead. Isolate the mains water
supply.
2. Fully drain all the water from the machine. The cold water can be drained via the Cold Tap and the hot water via
both the Hot Tap and the Hot Tank drain. CAUTION-THE WATER MAY BE VERY HOT. If the tank is heavily scaled
the drain may be partially or fully blocked requiring more caution. On the Floorstanding machine, the drain is on
the back of the machine and on the Countertop, it is underneath.
3. Remove the two screws at the back of the top Panel and lift off.
4. Carefully remove Tap Cover Panel (as shown by first
squeezing inwards and then out),and disconnect PCB
5. Remove the two screws at the top of the front panel and in the
case of a Floorstanding machine, open the Door Panel and
slacken off the two screws at the bottom. (You may if you prefer,
remove these completely). Remove the front panel by lifting it
upwards slightly first, then away keeping it clear of the taps.
With a Floorstanding machine, the Door Panel will then need
lifting off its lower hinge pin and setting aside.
N.B. Be careful to avoid damaging the high quality finish to the
panels whilst these are removed from the machine.