Page 6
3B-390977NU – 01/17
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
8.4
AUTO CLEANING MENU
Pressing the Cleaning/Tools button gives access to the cleaning menu
Display shows “CLEA” (cleaning) in the timer zone and the intensity in the temperature
zone.
By default the last cycle used is displayed.
Possible selections:
- 3 cleaning intensities
- Rinse function
- Cleaning product priming function
Intensity
Time
6/10 lev
20 lev
1
17 min
26 min
2
26 min
36 min
3
36 min
37 min
Rin
2 min
2 min
Pri
2 min
2 min
The priming function allows the detergent delivery circuit to be refilled when the
container is changed so that efficiency is maintained
Pressing the “Start button” starts a wash cycle.
Pressing the Cleaning/Tools button or any
inactive zone exits this menu and returns to the
previous screen.
3
USB PORT SOCKET (ACCESSORY)
The USB port socket is fitted with silicone protective cover.
Warning !
♦
Always put the protective cover in place (lowered to protect connections) whenever the socket is not in use.
♦
Never “clean” connections with a water hose or a sponge. (If the silicone cover is used and put back in place after use, no
maintenance is necessary).
♦
The guarantee will not apply if these recommendations are not observed.
4
ERROR MESSAGES
4.1 ERROR MESSAGES
Message on the screen
Consequences
What to do?
i31 : Electronics overheating: Temperature
reduced to 180°C
Cooking continues automatically at
a temperature below 180°C
Clean the lower and rear air intakes. If the problem
persists, call a service technician.
i33 : Core probe non function or not plugged in
Cooking stops
To continue cooking connect a probe or switch to timer
mode.
i81 : Water flow problem
Reduced functionality or Pause
the cleaning
Check the valve and water pressure.
If this message appears during washing: the cavity must
be rinced thoroughly.
If the problem persists, call a service technician.
i82 : Sticking solenoid
Reduced functionality
Switch off and call a service technician.
E46 : Electronic communication fault
Cooking stops
Possible to launch safe mode: convection mode at
175°C (see guidance and info about the control screen).
E53 : Ventilation non function
Cooking stops
Switch off and call a service technician.
E61 : Ambient probe short circuit
Cooking stops
Switch off and call a service technician.
E62 : Ambient probe non function
Cooking stops
Switch off and call a service technician.
E68 : Cavity at +290°C
Cooking stops
Switch off and call a service technician.
E72 : Electronics at over + 75°C
Cooking stops
Switch off and call a service technician.
E73 : Detergent pump faulty or on permanently
Drain the hydraulic circuit.
Reduced functionality
Switch off and call a service technician.
