BOMBARDIER SeaDoo Speedster 200, Operator'S Manual

Page: 84 / 113

85
TROUBLESHOOTING
The following chart is provided to help in diagnosing the probable source of simple
troubles. You may be able to solve many of these problems rather quickly, but
others may require the skills of a mechanical technician. In such a case, consult
an authorized dealer for servicing.
Nothing is Working in the Electrical System
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
No beeps are heard when
installing safety lanyard on
DESS post.
• Main battery cut-off
switch is turned OFF.
• Verify and turn ON.
Monitoring Beeper Coded Signals
NUMBER OF BEEPS POSSIBLE CAUSE REMEDY
2 short (while installing
safety lanyard on DESS
post).
• Everything is correct with
the safety lanyard (good
contact and right lanyard
cap).
• Engine can be started
normally.
1 long (while installing
safety lanyard on DESS
post or when pressing
start/stop buttons in some
cases).
• Bad connection between
safety lanyard cap and
DESS post.
• Remove and reinstall the
safety lanyard on the
DESS post. Two short
beeps should be heard
which indicates the
system is ready again to
allow engine starting.
• Wrong safety lanyard. • Use the safety lanyard
that has been
programmed for the boat.
If it does not work, refer
to an authorized dealer.
• Dirty safety lanyard cap. • Clean.
• Improper operation of
MPEM or defective
wiring harness.
• Refer to an authorized
dealer.
4 short (while pressing
start/stop button with
safety lanyard already
installed).
• Shifter is NOT in neutral. • Place shifter in neutral.
While moving the shifter,
1 short beep indicates you
reached the neutral
position.
1 short (while moving
shifter to neutral).
• Confirmation that shifter
is now in neutral .
• Engine is now ready to be
started.
8 short. • Defective MPEM
(memory).
• Refer to an authorized
dealer.
Continuous.
• Engine(s) overheating. • Refer to ENGINE
OVERHEATS below.
lmo2004_002a.book Page 85 Wednesday, May 14, 2003 11:10 AM