BOMBARDIER SeaDoo Speedster 200, Operator'S Manual

Page: 49 / 113

49
Installation
– Lift connector cap.
– Insert post in connector hole. En-
sure to align hole keyway with post
screw head.
– Firmly push downward to engage
terminals.
– Push lock ring downward. Turn until
locked. It may be necessary to
slightly turn it to allow its insertion
in the hole.
– Check light operation. See LIGHT
SWITCH as mentioned earlier in
this section.
TYPICAL
1. Lift
2. Align screw in groove
3. Push downward
4. Turn to lock
CAUTION: Ensure dielectric grease
is present in connector area of light
to prevent corrosion.
36) Mooring Cleats
When mooring to a dock, it is recom-
mended to secure with both front and
rear cleats. The use of dock lines with
sealed air fenders is recommended to
protect your boat.
CAUTION: Never use mooring cleats
to pull anything or to lift the sport boat.
37) Deck
Flat surface of boat, deck should be
kept clean and clear.
38) Fuel Tank Cap
1. Fuel tank cap
Unscrew the cap counterclockwise to
allow fuel tank filling. Fully tighten
when finished.
1
2
3
4
F04L0LY

WARNING
Always stop the engines before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated ar-
ea. Do not smoke or allow open
flames or sparks in the vicinity. Fuel
tank may be pressurized, slowly
turn cap when opening. Keep craft
level. Do not overfill or top off the
fuel tank and leave craft in the sun.
As temperature increases, fuel ex-
pands and might overflow. Always
wipe off any fuel spillage from the
craft. Never use an open flame to
check fuel level.
F13L1FY
1
lmo2004_002a.book Page 49 Wednesday, May 14, 2003 11:10 AM