Bomar Ergonomic 320.250 GAC, Operating Instruction

Page: 50 / 143

50
Manual version: 1.02 / Mar. 2010
Manual rev.: 1
O
v
lá
d
á
n
í
s
tr
o
je
B
e
d
ie
n
u
n
g
d
e
r
M
a
s
c
h
in
e
M
a
c
h
in
e
c
o
n
tr
o
l
4. Insert the first layer of the material, set the vices at a distance of 3 mm
from material, and fasten the levers of gripping cubes.
5. Insert residual layers of the material. Release again the fastening cube of
the vertical pushing cylinder and adjust its jaw to distance 3 mm from the
material.
6. Fasten the clamping cube of the vertical cylinder.
7. Release the pressure roller and adjust it to press the bundle from the
upper side on the feeder vice.
Make sure the roller is not too loose. The roller has to touch the material while
moving; the material must be in contact with the roller and not move about
freely.
Make sure the roller does not have too much pressure on it.
It is recommended to weld the layers together on the rear side during bundle
cuts. Main switch must be switched off during welding.
3.8. Vkládání materiálu
•
Nepohybujte se pod zdviženými b
ř
emeny
Pozor!
If the distance is too large, the machine displays „no
material inserted“