23
Use IP video output
Setting Camera over the LAN
To view and configure your camera via the local area network (LAN), you need to install the VMS (Video Management
System) to access the camera
.
1.
Connect your camera and your PC as shown in the figure below to ensure the routing is available.
2.
Use VMS or IPC-Search-Tool to search available cameras on the network automatically.
3.
Modify the camera settings if necessary, including its IP address and subnet mask.
NOTE!
The default IP address is “192.168.0.13”. The default username is “admin”, and the default password is
“admin” or “123456”.
To access your camera from a different subnet, set the gateway for your camera after you log in.
Accessing Your Camera
For camera models with IP output, you can manage and control through the web interface from a PC.
System Requirements for Your PC
Item
Requirements
Operating
System
Microsoft Windows 8/Windows 7/Windows XP (32-bit or
64-bit). Microsoft Windows 7 (32-bit) is recommended.
CPU
2.0 GHz or higher, dual-core. Intel i3 CPU or higher are
recommended.
Memory
At least 1 GB. 2 GB (or higher) is recommended.
Graphic
Card
At least 128 MB display memory. Mainstream discrete
graphics with more than 1 GB display memory are
recommended. The hardware should support DirectX9.0c.
Note: Make sure that the latest driver is installed on graphic
card.
Sound
Card
Essential.
Note: The intercom and voice broadcast require the latest
driver on sound card.
Network
Card
Gigabit
Ethernet
network
cards
(or higher) are
recommended.
