39
Use Bolin PTZ Controller for IP Control
Connect the KBD-1010-RNV keyboard controller to the Dante AV network switch from the IP port on the back of the
controller. Use POE to power up the controller. (12VDC power adapter included can also be used.)
IP Configuration
The controller IP address must be within the same subnet as Dante AV camera.
The IP address can be set to either STATIC or DHCP.
•
If setting the IP address to DHCP, move the cursor to the Type field, and rotate the Zoom Speed dial to change
the value to DHCP. Click the Zoom Speed dial to save
•
If setting the IP address to a STATIC address, ensure that the Type field shows STATIC, and then rotate the P/T
Speed dial to move the cursor between
the IP address octets. Move the cursor to
each octet and use the alphanumeric
keypad to enter its value. Rotate the P/T
Speed dial to move to the next octet and
repeat until all IP address octets are set
to the desired values.
•
Click the Zoom Speed dial to save
•
Edit the Subnet Mask and Gateway as
necessary to communicate on your
network
•
Click the Zoom Speed dial to save
•
Exit this menu
CAMERA SETTING
>KEYBOARD SETTING
EXIT
Main Setup Menu
>IP CONFIGURATION
BUTTON LIGHT
ASSIGNED KEY: F1
FACTORY DEFAULT
GPI I/O
PASSWORD SETTING
JOYSTICK ZOOM: ON
MODEL INFO
VISCA IP SETTING
CONTROL MODE
Exit
Keyboard Setting Menu
>IP CONFIGURATION
BUTTON LIGHT
ASSIGNED KEY: F1
FACTORY DEFAULT
GPI I/O
PASSWORD SETTING
JOYSTICK ZOOM: ON
MODEL INFO
VISCA IP SETTING
CONTROL MODE
Exit
Keyboard Setting
Menu
>Type: STATIC
IP Address
192. >168. >1. >100
Subnet Mask:
255. 255. 255. 0
Gateway:
192. 168. 1. 1
Exit
IP Configuration Menu