Boca FDSP34AI, Installation Manual

Page: 39 / 68

39
Installation
The MODEM is equipped with a USOC RJ-11 standard miniature modular jack and
is designed to plug directly into a modular jack.
DOC Compliance Statement (Canada)
The Canadian Department of Communications label identifies certified equipment.
This certification means that the equipment meets certain telecommunications
network protective operational and safety requirements. The Department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company’s inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly (telephone extension cord).
The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations. Repairs to certified equipment
should be made by an authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunction, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure, for their own protection, that the electrical ground connections
of the power utility, telephone lines, and internal metallic water pipe system, if
present, are connected together. This precaution may be particularly important in
rural areas.
CAUTION Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority or electrician, as
appropriate.
The Load Number (LN) assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop which is used by the device to
prevent overloading. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the load numbers of all the
devices does not exceed 100. The Load number appears on the bracket of the On-
Line EXPRESS Modem.
CAUTION: Telecommunications voltages and currents can exceed the limits of
safety extra low voltage (SELV), resulting in personal injury. Do not touch any
components on the modem’s printed circuit board when power is applied, or the
telephone cable is plugged in. Avoid installing, handling the telephone cable, or
changing the jumper settings on the modem during any weather activity where
lightning strikes may occur.
To be installed in UL-listed and CSA-certified computers with instructions on
how to add/remove expansion cards
.
Compliance Information