25
Testing the Connection
Testing the Connection
1. Check that you have made all connections and with your
computer powered on, check for a dial tone on a phone set
if one is connected.
2. If you do not have communications software already
installed, you may install the software supplied with the
On-Line EXPRESS. Refer to the diskettes and manual for
installation instructions. After installing and starting your
communications software, enter terminal mode.
IMPORTANT: If you are not in terminal mode and you
type AT commands at the DOS prompt, a “Bad
Command or File Name” message will result.
3. Type in ATZ followed by ENTER and the
modem will respond with OK after a few
seconds.
4. Type ATH1 followed by ENTER and you
should hear a dial tone. To increase speaker
volume, refer to your communications
software or type the ATL3 command.
ATZ
OK
ATH1
OK
ATH
OK
Summary of Contents for FDSP34AI
Page 1: ...1 V 34 PRODUCT CODE MV 34AI FDSP34AI...
Page 2: ...2 On Line EXPRESS...
Page 67: ...67...
Page 68: ...68 On Line EXPRESS Manual Part No 9484 Rev 2 0...
