39
Appendix E: AT Command Reference
DATA COMMANDS
The modem will respond to the commands detailed below.
Parameters applicable to each command are listed with the
command description. The defaults shown correspond to default
values provided in the Product Configuration File (PCF).
Generic Modem Control
Z - Reset to Default Configuration
This command instructs the modem to reset to default values as
altered by non-volatile parameter storage. If the modem is
connected to the line, it will be disconnected from the line,
terminating any call in progress. All of the functions of the
command are completed before the modem issues the result code.
The DTE should not include additional commands on the same
command line after the Z command because such commands are
ignored.
Syntax
Z
Result Code
OK
&F - Set to Factory-Defined Configuration
This command instructs the modem to set all parameters to factory
default values defined in the product Configuration Table
The modem loads the factory default configuration (profile). The
factory defaults are identified for each command and in the S-
Parameter descriptions. A configuration (profile) consists of a
subset of S-Parameters.
Syntax
&F
Result Code
OK
AT Command Reference
manual2.p65
5/4/98, 12:37 PM
39
