6-18
On:
Sets the number of pulses to generate before inhibiting
output in Duty Cycle Mode.
Off:
Sets the number of pulses to inhibit before repeating the On
Cycle in Duty Cycle Mode.
Delaying the Start of Channel Output
Within any channel mode, the output of the channel can be delayed using the
wait parameter (within the CHANNEL menu):
Wait:
Sets the number of T
0
pulses to wait until enabling the
channel output.
Advanced Channel Menus (FUNC + A, B, C, D, E, F, G or H key)
Multiplexer Menu
-HGFE DCBA-
Multiplexed
Channels
Configuring the Channel Multiplexer
To define which channels are fed into the channel multiplexer, the corresponding
bit for the desired channel to add should be set to 1. All desired omitted
channels should have the corresponding bit set to 0.
Mux:
Enable/disable bit field.
Channel Gate Menu
Channel Enable
Channel Enable
Channel Enable
Ch Gate Mode:
(Gate Menu)
Ch Gate Mode:
Pulse Inhibit
Ch Gate Mode:
Output Inhibit
Logic Level
Logic Level
Setting the Sync Source
Although each channel receives its start pulse from the internal T
0
pulse, the start
pulse can be assigned such that the delay entered is relative to the T
0
pulse or
any other channel pulse. This allows dependent events to link. The unit will not
allow a circular chain of sync sources that would result in a channel triggering
itself. The delay entered is relative to the selected sync source.
Sync Source:
Selects the channel sync source.
Setting Channel Gate Control
When the global gate is set (Chan Menu), the channel can then use the gate
input with independent behavior from other channels.
