BMW X6 M50i 2021, Owner'S Manual

Page: 338 / 400

Failure performing a reset
Tires with special approval: the system will not
function correctly if a reset was not performed,
for example a flat tire may be indicated although
the tire inflation pressures are correct.
Malfunction
Message
The yellow warning light flashes and is
then illuminated continuously. A Check
Control message is displayed. It may not
be possible to identify tire pressure losses.
Measure
▷ A wheel without wheel electronics, such as
an emergency wheel, is mounted: have the
wheels checked, if needed.
▷ Fault caused by systems or devices with the
same radio frequency: after leaving the area
of the interference, the system automatically
becomes active again.
▷ For tires with special approval: the system
was unable to complete the reset. Perform a
system reset again.
▷ Tire Pressure Monitor malfunction: have the
system checked by a manufacturer service
center or another qualified service center or
repair shop.
Declaration according to NHTSA/
FMVSS 138 Tire Pressure
Monitoring System
Each tire, including the spare (if provided) should
be checked monthly when cold and inflated to
the inflation pressure recommended by the vehi‐
cle manufacturer on the vehicle placard or tire in‐
flation pressure label. (If your vehicle has tires of
a different size than the size indicated on the ve‐
hicle placard or tire inflation pressure label, you
should determine the proper tire inflation pres‐
sure for those tires.) As an added safety feature,
your vehicle has been equipped with a tire pres‐
sure monitoring system (TPMS) that illuminates
a low tire pressure telltale when one or more of
your tires is significantly under-inflated. Accord‐
ingly, when the low tire pressure telltale illumi‐
nates, you should stop and check your tires as
soon as possible, and inflate them to the proper
pressure. Driving on a significantly under-inflated
tire causes the tire to overheat and can lead to
tire failure. Under-inflation also reduces fuel effi‐
ciency and tire tread life, and may affect the vehi‐
cle's handling and stopping ability. Please note
that the TPMS is not a substitute for proper tire
maintenance, and it is the driver's responsibility
to maintain correct tire pressure, even if under-
inflation has not reached the level to trigger illu‐
mination of the TPMS low tire pressure telltale.
Your vehicle has also been equipped with a
TPMS malfunction indicator to indicate when the
system is not operating properly. The TPMS
malfunction indicator is combined with the low
tire pressure telltale. When the system detects a
malfunction, the telltale will flash for approxi‐
mately one minute and then remain continuously
illuminated. This sequence will continue upon
subsequent vehicle start-ups as long as the mal‐
function exists. When the malfunction indicator is
illuminated, the system may not be able to de‐
tect or signal low tire pressure as intended.
TPMS malfunctions may occur for a variety of
reasons, including the installation of replacement
or alternate tires or wheels on the vehicle that
prevent the TPMS from functioning properly. Al‐
ways check the TPMS malfunction telltale after
replacing one or more tires or wheels on your ve‐
hicle to ensure that the replacement or alternate
tires and wheels allow the TPMS to continue to
function properly.
Flat Tire Monitor FTM
Principle
The Flat Tire display detects a tire pressure loss
while driving and issues a warning if the tire pres‐
sure has dropped.
Seite 338
MOBILITY
Wheels and tires
338
Online Edition for Part no. 01405A38F56 - VI/21