BMW HP2 Megamoto 2007, Rider'S Manual

Page: 77 / 133

Pinch bolt of axle holder
Tightening sequence: 2x
each side, alternately
6 lb/ft (8 Nm)
Tighten right axle clamping
screws
3 to the specified tight-
ening torque.
Pinch bolt of axle holder
Tightening sequence: 2x
each side, alternately
Pinch bolt of axle holder
6 lb/ft (8 Nm)
Remove front wheel stand.
Ease brake calipers onto brake
disks.
Install mounting screws 1 with
appropriate torque.
Brake caliper on slider
tube
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
disks.
Before driving off, check that the
braking effect kicks in without
any delay.
Operate brakes several times
until brake pads contact brake
disk.
Remove rear wheel stand.
Removing rear wheel
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
(
78)
7
75
z Maintenance