BMW HP2 Megamoto 2007, Rider'S Manual

Page: 56 / 133

Try to do most of your rid-
ing during this initial period on
twisting, fairly hilly roads, avoid-
ing high-speed main roads and
highways if possible.
Exceeding the specified en-
gine speeds while running
in will lead to increased engine
wear.
Adhere to the specified engine
run-in speeds.
Do not exceed the engine run-
in speeds.
Engine break-in speed
<4000 min -1
Do not accelerate at full throt-
tle.
Avoid low engine speeds at full
load.
After 300 - 750 miles (500 -
1,200 km), have the first in-
spection performed.
Brake pads
New brake pads must "bed
down" and therefore do not
achieve their optimum friction
levels during the first 300 miles
(500 km). This initial reduction
in braking efficiency can be
compensated for by exerting
greater pressure on the levers.
New brake pads can ex-
tend stopping distance by a
significant margin.
Brake early.
Tires
New tires have a smooth sur-
face. This must be roughened by
riding in a restrained manner at
various heel angles until the tires
are run in. This running in proce-
dure is essential if the tires are to
achieve maximum grip.
New tires have not
achieved their full adhesion
yet. There is a danger of
accidents when driving at
extreme angles.
Avoid extreme angles.
Parking your
motorcycle
Placing on side stand
If the ground is soft or un-
even, there is no guarantee
that the motorcycle will rest firm-
ly on the stand.
Always check that the ground
under the stand is level and
firm.
Switch off the engine.
Pull handbrake lever.
Hold motorcycle upright and
balanced.
Use your left foot to extend
side stand fully.
The side stand is designed
to support only the weight
of the motorcycle.
Do not lean or sit on the
5
54
z Riding