BMW Motorrad HP2 Megamoto, Rider'S Manual

Page: 104 / 146

Charge disconnected battery
via onboard socket.
Comply with operating instruc-
tions of charger.
The motorcycle's onboard
electronics know when the
battery is fully charged. The
onboard socket is switched off
when this happens.
Charging disconnected
battery
Charge battery using a suitable
charger.
Comply with operating instruc-
tions of charger.
Once battery is fully charged,
disconnect charger's terminal
clips from battery terminals.
In the case of longer peri-
ods when the motorcycle is
not being used, the battery must
be recharged regularly. See the
instructions for caring for your
battery. Always fully recharge
the battery before returning it to
use.
Removing battery
Disconnecting the battery
causes the tripmeter and
the operating hours meter to be
reset.
Removing seat ( 50)
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Make sure that the motorcycle is
steady on its stand.
Switch off ignition.
An incorrect disconnection
sequence increase the risk
of short-circuiting.
Always observe the proper
sequence.
Remove battery ground wire 1
first.
Then remove positive battery
cable
2 .
Remove screw 3 of battery
holder.
Lay battery holder with cables
connected over frame to left.
8
102
z Maint
e
nance
ProCarManuals.com