BMC G3 B20A, User Manual, Page: 29 / 61

BPAP System User Manual
26 / 57
Fig. 13-8
WARNING!
• Do not touch the heating plate of the device when it is in operation, otherwise you may get
burned. Turn off the humidifier when the heated humidifier is not in use.
CAUTIONS!
• Generally speaking, the humidity level inside the mask is low when the water temperature
is low.
• The greater the difference between the temperature inside the air tubing and the room
temperature, the more likely condensation will occur inside the tubing.
• If there is only a small amout of condensed water droplets in the tubing in the morning
after treatment, it means that the humidity level is appropriate; if there is a large amount of
condensed water droplets inside the tubing and / or the mask, the humidity level is too high
and should be set lower. Nasal dryness means that the humidity level is too low and should
be set higher.
14. Using the SpO
2
Kit
Connect the SpO
2
Kit to the device according to the user manual for the SpO
2
Kit. After the
device is powered on, start the device, the screen of the device then displays the Main
Interface shown in Fig. 14-1. The patient's blood oxygen saturation and pulse rate can be
clearly seen during the course of treatment.
Fig. 14-1
For more details, please refer to the SpO
2
Kit user manual.