BlueLine VORTEX 8000Q, Service And Operation Manual

Page: 28 / 100

SECTION 2
BLUE
LINE VORTEX 8000Q 23
7. Disengage PUMP and PTO switches.
8. Activate the valves on all cleaning tools.
This will relieve any remaining pressure.
Disconnect the cleaning tools and solution
hoses and return them to the vehicle.
9. Drain the waste tank, disposing of
wastewater in a suitable and proper location.
!
NEVER dispose of wastewater in a storm
drain, water way or on ground areas.
Always dispose of waste in accordance with
Local, State, and Federal laws.
10. Remove the strainer basket from the pre-
filter box. Clean out any debris and re-install.
NOTE: Damage may occur to the vacuum
pump if strainer basket is damaged or
improperly installed.
11. Inspect the vacuum inlet filters inside the
waste tank daily . Remove and clean the filters
if there is any lint or debris present.
Replacement and maintenance of the filters
will prevent rust and corrosion from entering
the vacuum pump.
NOTE: To remove the vacuum inlet filters,
grip the plastic hexagon section of the
filters. Gripping the filters by the screen
will collapse or destroy the filters. Replace
the filters after cleaning until hand tight.
NEVER operate this unit with the filters
removed, damaged or improperly installed.
12. At the end of the work day, rinse out the
pre-filter box and the waste tank with fresh
water. A deodorizer may be added to prevent
bacterial growth.
13. Clean the vehicle interior, unit, tools,
hoses etc., as needed. Inspect
ALL
equipment
and accessories for any damage, leaks, wear,
etc.
Water under high pressure at high
temperature can cause burns, severe
personal injury, or fatality
FREEZE PROTECTION
!
If the unit is exposed to freezing weather
conditions, the water inside of the unit may
freeze, resulting in SERIOUS DAMAGE to
the unit. Always park the unit in a heated
building when not in use . If a heated
building is not available, drain all water
from the mobile cleaning unit.
While in operation, avoid long periods of shut
down as the unit generates heat while running.
Keep the unit running just prior to leaving for
the next job.