BlueLine VORTEX 8000Q, Service And Operation Manual

Page: 31 / 100

SECTION 3
26
BLUE
LINE VORTEX 8000Q
MAINTENANCE CHART
Engine Daily Check engine oil level.** Fill to proper level.
Engine Coolant Daily Check coolant level in overflow bottle. Fill to proper level.
Vacuum Pump Daily Spray WD-40 (or Equivalent) into the lubrication valve for 5 seconds.
Water Pump Daily Check water pump oil level.*** Fill to proper level.
Vacuum Inlet Filters Daily* Inspect filters, clean and or replace if required.
Pre-Filter Box Strainer Basket Daily Empty and clean stainless steel basket.
Vacuum Hoses Daily Rinse with fresh water.
Waste Pump-Out (Optional) Daily* Inspect and remove any debris or sediment. Rinse with fresh water.
Engine Weekly Check air cleaner for damaged, dirty, or loose parts.
Engine Weekly Inspect air intake and cooling areas. Clean if required.
Vacuum Pump Weekly* Check vacuum pump oil level. Fill to proper level. Do not overfill.
Vacuum Inlet Filters Weekly Remove filters and clean.
Water Box Weekly* Inspect and clean filter. Replace if damaged.
Battery Weekly* Check fluid level. Fill with distilled water only. Do not overfill .
Wye-Strainers Weekly* Clean and remove any debris.****
Engine Monthly Inspect drive belts for wear. Replace as needed.
High Pressure Solution Hoses 25 Hours Inspect for wear, damage, or impending rupture. Replace if damaged .
Drive Line 50 Hours Lubricate drive line..
Pressure Regulator 100 Hours Lubricate o-rings. Use only o-ring lubricant part # 13-003.
Battery 100 Hours Clean battery terminals.
Engine 200 Hours Clean engine air filter.
Xentherm 500 Hours Replace xentherm heat transfer fluid.
Water Pump 500 Hours Change crankcase oil.***
Pulleys and Hubs 500 Hours Check pulley and hub set screws for proper torque.*****
Vacuum Pump 500 Hours Drain, flush, and replace oil.*******
Chemical Pump 1000 Hours Change diaphragm and check valves. Inspect disk.
Check Valve 1000 Hours Check Teflon seat for abnormal wear or debris. Replace as needed.
Accumulator
2000
Hours
Replace if needed.*
To maximize the operating life and performance, use only recommended oils, filters and greases.
*Or as often as required.
***Change water pump crankcase oil after first 50 hours of operation
****Inspect after first week of operation, and remove any debris present. Inspect again after 2 to 4 weeks .
*****Check pulley and hub set screws after first 50 hours of operation, and again at 100 hours of operation.
******Or every 6 Months . Whichever comes first.
*******Or Yearly . Whichever comes first.