To Prime The Pump:
1
Open the
App Drawer
2
Select
Prime
3
Select
Start
to Prime the pump
4
Pump will run at 100% motor
speed for sixty seconds
5
Pump will remain in
Prime
Input
8.7
Prime
This mode allows the user to prime the pump at 100% motor speed for sixty seconds. After the
prime is complete the pump will remain in this mode ready to be primed again.
To exit: select another input method.
Page 26
®
FLEXFLO A4
8.0
Input Setup
Page 27
®
FLEXFLO A4
8.0
Input Setup
To Enable
:
Manual Cycle Adjust
1
Open the
App Drawer
2
Select
Manual Cycle
Adjustment
3
Select
Settings
to configure
Manual Cycle Adjustment
settings
4
Set
Pump Speed
(0.04 - 100 percent)
5
Set
Duty Time
(1 - 1,000,000 seconds)
6
Set
Cycle Time
(1 - 1,000,000 seconds)
7
Confirm by pressing
Save
8.8
Manual Cycle Adjust
This input mode allows the user to run the pump at a set motor speed (Pump Speed) for a set
amount of time (Duty Time) after which the pump will pause for a set amount of time (Cycle
Time). This cycle will repeat until the user presses the STOP button.
Default settings:
Pump Speed = 100% Motor Speed
Duty Time = 1.5 Seconds
Cycle Time = 4.0 Seconds
