Any operation. Any asset. Anywhere. ComCenter II User Guide v1.3
Page
16
of
32
© 2022 Blue Sky Network, All Rights Reserved
Via POTS/RJ-11
The same commands are used with the POTS/RJ-11 as with the Privacy Handset. However, because
there is no display of information on the POTS/RJ-11, watch the blink pattern on the status LEDs and
listed to audible beeps to confirm the mode setting.
To change the mode, take the POTS/RJ-11 phone off-hook and press the following keys:
*610 = Direct (1 blink, 1 beep)
*611 = DHCP Client (2 blinks, 2 beeps)
*612 DHCP Server (3 blinks, 3 beeps)
Additional useful commands using POTS/RJ-11:
*994 blinks the status LEDs and gives audible beeps according to mode setting.
Via the Embedded Webpage
Accessing the embedded webpage in the ComCenter II may not be possible unless the default DHCP
Client mode is compatible with your specific network. Once you access the ComCenter II webpage,
the mode can be changed by clicking on the ‘Configure’ button.
NOTE
: Changing modes will likely cause you to lose access to the webpage until the network or
direct connection is also configured to this new mode.
