ComCenter II User Guide v1.3
Page
11
of
32
© 2022 Blue Sky Network, All Rights Reserved
INSTALLATION AND GENERAL SETUP
Below please find the suggested mounting configuration for your fixed station terminal. Please
contact Blue Sky Network support if you are unsure about the mounting steps or the connectivity at
any stage of this installation.
NOTE
: Different wall materials require different mounting hardware. The proper screws/anchors
should be selected according to the materials used on your wall.
IMPORTANT
:
For proper operation, the SIM card installed in your ComCenter II must be activated by
your servicer provider and unlocked (i.e., PIN code turned off). If the PIN code has not been turned
off by your service provider, refer to Accessing ComCenter II Settings for a command to turn it off.
For security reasons, the ComCenter II can only turn off the Iridium default PIN code.
Wall Mounting
1)
Position the device at the
desired height, then mark
the screw locations with a
pencil.
2)
Anchor the mounting
screws on the wall, leaving
about 0.25” of the head
exposed.
3)
Hang the device on the
exposed screw heads and
then tighten until snug.
Swivel Mounting (
optional kit
)
1)
Affix the round base to a
sturdy surface using
anchors and/or screws as
appropriate for the
material.
2)
Attach the ComCenter II
to the mounting plate
using the center keyholes.
3)
Plug the Privacy Handset
into the ComCenter II.
