Blue Seal SD 5 EC BT2, Instructions For Use And Maintenance Manual

Page: 23 / 52

21
ENGLISH
Part 2: Reserved for Operator
2.8 REGENERATION CYCLE SG4E2
Resin regeneration is only possible with the door
CLOSED and the tank EMPTY.
2.8.a FILLING THE SALT TANK
IMPORTANT
The tank is to be filled when alarm F4 appears on the display.
First of all make sure that there is salt in the specific
container and proceed as follows:
1. Unscrew the cap of the salt tank and introduce salt tablets
suitable for water softening.
2. Screw the plug back on all the way to make sure the
tank is sealed
2.8.d MANUAL REGENERATION OPERATIONS
(at the user’s discretion)
With the machine ON and a FULL tank, perform the fol-
lowing operations:
2.8.b RESIN REGENERATION OPERATIONS
(AUTOMATIC) (only for mod. "A")
IMPORTANT
Resin regeneration is always done manually and can be
activated at the end of the daily activities.
Once the cycles set in parameter CRT are r
eached, A9 appears on the display, which
means REGENERATION REQUIRED.
The START button turns red.
ATTENTION
Press the START button with an impulse to not perform the
regeneration phase
2.8.c RESIN REGENERATION OPERATIONS
(AUTOMATIC
Touch the START button for a
few seconds
The automatic REGENERATION phase begins.
The START button turns WHITE
The following appears on the display:
“SALT INTRODUCTION”.
IMPORTANT
The regeneration phase will start with a set drain time.
During this time the operator must open the door,
lift the overflow and close the door.
Touch the SCROLL key
Select the REGENERATION
function from the display
Touch the START key.
The MANUAL REGENERATION
phase begins.
Unhook the overflow
The START button turns
WHITE
The following appears on the
display:
“SALT INTRODUCTION”
“RESIN REGENERATION”,
“RESIN RINSE”
At the end of the cycle, the machine switches off automa-
tically and the display reads OFF.
The machine is now ready for use.
ATTENTION
f the above operation is not performed, at the end of the
time initially set for the drain phase, the VASPIE alarm,
i.e. full tank, appears on the display.
ATTENTION
Only an authorised technician can program the regeneration
parameters.
The machine is now ready for use.
ATTENTION
At this point the dishwasher carries out all the necessary
operations automatically for a preset time, during which the
machine cannot be used.
At the end of the cycle, the ma-
chine switches off automatically
and the display reads OFF.