Blue Seal SD 5 EC BT2, Instructions For Use And Maintenance Manual, Page: 18 / 52

16
2.1.d Interruption of the cycle
The wash cycle can be interrupted temporarily in two ways
To start the wash cycle, touch
the START key.
The START key turns BLUE
during the entire duration of the
wash cycle.
The countdown of the cycle ap-
pears on the display in seconds.
The following phases are per-
formed during a complete cycle:
° WASH
° PAUSE*
° RINSE
* DRAIN
(only in R versions))
2.1.c STARTING WASH CYCLE
IMPORTANT
The selection of starting MANUAL or AUTOMATIC
cycle must be made by an authorised technician.
STARTING AUTOMATIC WASH CYCLE
To start the wash cycle in AUTOMATIC mode (with
opening and closing of the door), the cycle start
mode must be changed.
IMPORTANT
This operation must be carried out by an authorised
technician during installation..
STARTING MANUAL WASH CYCLE
ATTENTION
It is recommended to check the level of the detergent
and rinse agent daily.
TERMOSTOP
For hygienic purposes, machine operation always achie-
ves the ideal rinsing temperature.
If the temperature is not sufficient, washing is prolonged
automatically until the conditions necessary for ideal
rinsing are achieved.
The pause to reach the ideal temperature can be pro-
longed to a maximum of 8 minutes.
ATTENTION
When the water in the boiler is not at the proper tempe-
rature, the temperature value of the SET RINSE water
FLASHES on the display.
The remaining time for the cycle to be completed also
appears on the display.
Once the set temperature value is reached, the countdown
resumes until the cycle is completed.
1) by opening the door acting
as EMERGENCY.
OPEN F1 appears on the display
When the door is reclosed, the
cycle resumes from where it
stopped.
2) By pressing the START button
during the cycle, the wash phase
reaches a set value, guaran-
teeing a minimum washing time.
Once the wash cycle is com-
pleted, the SET temperatures
appear on the display.
The START key turns STEADY
GREEN.
At the end of the wash cycle, remove the dish rack and
shake it likely to remove the last drops remaining on the
washed items.
Leave the objects to try and remove them from the dish
rack with clean hands.
Set everything on hygienic and surely stable surfaces.
2.1.e DRAINING WATER FROM THE TANK
2.1.e .1 Drain for machines without drain pump
The water in the tank can be emptied at any time of the
day depending on the filth accumulated.
To perform this operation, pro-
ceed as follows:
- SWITCH OFF the dishwasher
by setting the START key to OFF
OFF appears on the display
- Release the overflow (14)
allowing the water to drain
completely from the tank;
- Extract the tank filter (15) and
clean it.
At the end of the cycle, put the
filter (15) and the overflow (14)
back into the respective seats
(example)
Part 2: Reserved for Operator
ENGLISH