Blue Flame BFCO-1, Installation & Operation Manual

Page: 37 / 40

37
Locate the new regulator kit.
Carefully remove the new spring in this bag, and place it where the old one was removed. Place the new spring
retainer cap on top of the spring and carefully turn it clockwise to begin tightening the spring. Using a fine
screwdriver, carefully tighten the retainer ring down until it is 0.20” (slightly less than 1/4” from the top surface
of the spring assembly. This will set the regulator to the 11” W.C. needed to run the burners on LP gas.
To make sure pressure from regulator is correct, and to fine tune pressure, remove brass pipe plug on burner
manifold and connect sensitive gas pressure gage to measure manifold pressure.
Reconnect manifold to gas tube and reinstall manifold in oven, making sure orifices are correctly centered in
burners. Apply new cable ties to hold electrical wires to manifold.
Make sure all gas connections are tight and sealed. Reconnect oven to LP gas with maximum pressure coming
into oven to be no more than 11” W.C. from external regulator in between gas tank and oven.
Plug oven into 120 volt outlet.