8 AQT8-QAM/IP
User Manual
2.2 Product Application & Description (Continued)
Description:
Following are pictures of the front and rear of the unit:
-20dB QAM RF TEST:
"F" female connector for RF QAM output signal, 20dB lower than the actual RF QAM output.
Used for test purposes, without taking the unit out of service.
ASI OUT:
For in-service monitoring of selected IP output
Input STATUS LEDS # 1 through 8:
LED is Off = input channel tuner not locked.
LED is Green = input channel tuner is locked.
LED is RED = error detected in input stream.
LED blinks = corresponding QAM output is off or in CW mode
POWER LED:
If the LED is Green, the AC power is detected. If the LED is Off, it will indicate one of the following:
(i) AC power is not connected, or
(ii) AC power is connected but the power supply is defective. Unit must be sent to factory for repairs.
DATA OUT (GIGE):
RJ45 for 1000Base-T Ethernet (GigE) interface for IP DATA outputs.
CONTROL (10/100):
RJ45 connector for 10/100Base-T Ethernet interface for monitoring and configuring the unit
via standard web browser. Only static IP address can be assigned to this interface. (Factory Default: "172.16.70.1")
IP RESET:
When pushed and held for about 10 seconds, resets the IP address, Usernames, and Passwords to Factory
Default values as follows:
IP address = 172.16.70.1
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
NOTE:
Power must be reset for this to take effect
3
2
1
4
1
4
2
5
3
6
7