22 AQT8-QAM/IP
User Manual
"
Bitrate
" check box(es) (Figure 6.3b & 6.3c) will display ONLY when the “Average Bit Rate” setting on the bottom of
the Admin Page has been set to “Enable” and the “Edit” button ( ) has been clicked on (Figure 6.3a). Checked
programs will have the unit overwrite the peak video rate declared in the video elementary stream. This is used
only when the content provider is exceeding the bitrate compared to what is declared in the MPEG 2 programs
stream. Refer to in Section 6.11 for more information.
Step 1: Click the
edit
button
Step 2: Put check marks next to desired programming by clicking the appropiate box(s)
Step 3: Select the output
Step 4: Click
Add
Step 5: Click
Save
2
13
14
11
12
15
6.3 "Main > Input Map" Screen (continued)
6.4 "Main > MPTS Output Config" Screen
The “Main > MPTS Output Config” screen (Figure 6.4, next page) is a “read and write” screen where the following output
parameters are configured and displayed for each multiplexed MPTS output stream. This tab is only displayed when the
output mode (see section 6.6) is active.
1
In the section entitled “MPTS Output Configuration”, the user can select and configure the following parameters of the
output:
TS ID:
Enter the identification number for the Transport Stream (TS) output. The range is 1 to 65535. The TS ID
assigned to each multiplexed MPTS output stream must be unique.
2
26
Figure 6.3c - "Input Map" Screen with Average Bitrate Enabled
15
The MAXIMUM total number of outputs is 20. See Appendix C for more details.
Remember
to
click
on
the
SAVE
button
to
apply
the
new
values/configurations.
Total Output Bitrate:
indicates the total bitrate of all current and previously selected programs. Total bitrate should
not exceed TS bitrate assigned in MPTS output config page, item , default is 38800000
To select programs for IP Output:
10
2
