![background image](http://html.mh-extra.com/html/blonder-tongue/aqt8-ip/aqt8-ip_user-manual_2774527014.webp)
14 AQT8-QAM/IP
User Manual
Step 5 - Check SNR
Go to the "Status" page:
>22 dB SNR for 8VSB; >33 dB
for QAM 256 is recommended.
(Increase the RF input level as
required to achieve the desired
SNR).
Step 6 - Configure QAM Output
Go to "QAM" page to setup output channels:
Select the 1st channel for each set of QAM outputs.
Ensure all outputs are "enabled" and "CW
Control" is not selected/enabled.
"Output Select" allows user to select TS
stream for each QAM output. Options are
as follows:
• IP Out 1 through IP Out 8
• Default IP or Default RF: QAM1 gets TS
from IP Out 1 or RF1 (input), QAM2 gets
TS from IP Out 2 or RF2 (input), and so
on.
(NOTE: When using any of the IP settings,
the particular IP output must be “Enabled”.
See Step #8.)
Select the QAM modulation under
“Output QAM Mode".
Click "Save".
1
1
2
3
4
5
1
2
4
3
5
1